Ensure correct model Supaheat II has been purchased depending on what gas is supplied to the property. Check any warnings in the instruction manual to make sure that the heater is safe to be used. Do not place the heater on any uneven surface. Ensure adequate ventilation to the room and around the heater.
Check gas heater has a “C” size 1.5V battery. Ensure the room you want to use the heater in has a Bromic quick release valve installed. Plug the bayonet fitting at the end of the hose into the quick release valve on the wall. Check for gas leaks.

Hold down the red “on/off” button for 10 seconds. You should hear the clicking noise of the ignitor. The heater should spark and gradually light the tiles.
If heater does not light, repeat step 2. Repeat no more than 3 times and wait 30-seconds
between attempts.

To light the second row of tiles, press the black button in for “high” heating mode. To turn the heater off, push the red “on/off” button and it will lift up and shut the gas off.

To turn the heater off, push the red “ON/OFF” button down. This will cause the “PILOT/IGN” button to lift up. Ensure heater has turned off.